Так у них в правилах написано: 16. Handguns must be based on and visibly resemble the profile and contours of the classic 1911-genre design. This
means a single-stack, one piece metal frame, slide with stirrup cuts, and a dust cover (with or without an
accessory rail) which has a maximum length of 75 mm when measured from the leading edge of the dust cover
to the rear of the slide stop pin.
16.1 Magazine wells cannot exceed a maximum outside width of 35 mm. Compliance is checked by way of a
35 mm wide, and at least 5 mm deep, notch carved into the outside of the box, or by use of a ruler or
caliper, as approved by the officiating Range Master.
А у нас:
16. Пистолеты должны конструктивно и внешне соответствовать модели Кольт 1911 или ПМ.
16.1 Расширители магазинов должны иметь внешний размер по ширине не более 35 мм и не
более 5 мм глубиной. Данные Измерения проводятся с помощью одобренных Главным
судьей измерительных инструментов.
Разница есть и огромная